ROBBE Arcus E 2.2 Instrucciones de operaciones descargar pdf (Pagina 3)

Building and Operating Instructions - Arcus E 2.2 ARF No. 2568

Fig. 1

- The picture shows the set contents of the Arcus E 2.2.

Fig. 2

- Connect the pre-formed end of the pushrod to the elevator

horn.

Fig. 3

- Attach the tailplane to the mount on the fin using the two

M3 x 12 mm screws.

Fig. 4

- Now slide the wing joiner spar into one wing panel.

Take care to use the correct end, as shown in the pho-

tograph.

Fig. 5

- Fit the wing, at the same time threading the two servo

leads (aileron and airbrake servos) through the fuselage,

as shown in the picture.

Fig. 6

- Now slide the second wing panel into place, following

exactly the same procedure as described in Step „5“.

Fig. 7

- Once the wings are in place, attach them to the fuselage

using the M4.0 x 20 mm screw.

Fig. 8

- Tighten the wing joiner screws on the underside of the

wings for additional security.

Fig. 9

- Now connect the aileron servo leads and the airbrake ser-

vos using two Y-leads.

Take care to maintain correct polarity when connec-

ting the leads.

Fig. 10

- Wiring diagram for control functions, retractable po-

wer unit, airbrakes and retractable undercarriage

(the stated channel assignment is correct for robbe Futaba

receivers)

1. Connect the servos to the receiver.

2. Connect the mixer to the speed controller.

Aileron

servo 1

Aileron

servo 2

Elevator

servo

Channel 2

Rudder

servo

Channel 4

Airbrake servo 1 Airbrake

servo 2

Retract

servo

Channel 5

Channel 1 (Y-lead) Channel 6 (Y-lead)

ESC

(speed controller)

Retractable power unit mixer

Auxiliary channel (Aux)

for retractable power unit

LiPo battery

Retractable power

unit servo

Channel 7

1 2 3 4 5 6

1 2 3 4 5 6 7 8 ... 31 32

Comentarios a estos manuales

Sin comentarios

ROBBE Arcus E 2.2 Instrucciones de operaciones Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Juguetes con control remoto ROBBE Arcus E 2.2